Monday, January 21, 2013

Heatlink EasyFit Plumbing PEX Manifolds


Heatlink Easyfit Pex Manifolds come in 2 and 3 Port Tees and are sold with 1/2" PEX adapters. So just order the actual amount of ports you need and you should be good to go. There are several different End Connection you need to choose from as well as 3/4" Tee to allow you to send hot or cold water to a separte plumbing manifold in a different location. If you want to use this manifold with 3/8 Inch PEX tubing - buy our Coupler 1/2 by 3/8 inch for each branch you want to use with 3/8 Inch PEX. Use silicone lubricant to lubricate dry o-rings to ensure a tight seal. In case a leak develops during testing, remove pressure from system, clean the o-ring, and reapply silicon lube. When placing the manifold into the supporting bracket, place the bottom snap-in lock in the bottom (braced) notch in bracket and then rotate it so that the top snaps into place. In order to prevent stress on the manifold supply end connections, the supply piping must be braced or supported, parallel to the manifold and centred with the manifold’s inlets.










  • A) Part 22199 - Closed End Cap
  • B) Part 22195 - 3/4" EasyFit Run End Connection
  • C) Part 22001 - Compression Stop Tee with Shut Off
  • D) Part 22002 - 2 Port Tee with 1/2 Inch PEX Adapters
  • E) Part 22196 - 1 Inch MPT Supply End Connection
  • F) Part 22194 - 3/4 Inch EasyFit Supply End Connection
  • G) Part 22193 - 1/2 Inch EasyFit Supply End Connection
  • H) Part 22180 or Part 22181 - Red or Blue Shut-off Caps
  • Part 22095 - Cap for 1/2 Inch Fittings to shut off unused ports (Not Shown)
  • Part 22196 - 1 Inch MPT Supply End Connection (Not Shown)
  • Part 22003 - 3 Port Tee with 1/2 Inch PEX Adapters (Not Shown)
  • Part 23015 - Manifold Compression Connector for Part # 22001 - for 1/2 Inch PEX Tubing (Not Shown)
  • Part 23032 - Manifold Compression Connector for Part # 22001 - for 3/4 Inch PEX Tubing (Not Shown)

Heatlink can be found a this link:


Houseneeds.com
866-432-8123  for Sales Agents